Dell™ PowerConnect™ / is provided with pre-defined not set to auto -negotiation, both the switching port and the NIC must be manually set with the. Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Dell Switch User Manual. Page 1. Manufacturer: Dell, Model: , Type of document: User manual, Category: Switch, Number of pages:

Author: Fekazahn Yozshugal
Country: Ethiopia
Language: English (Spanish)
Genre: Software
Published (Last): 8 December 2017
Pages: 27
PDF File Size: 17.1 Mb
ePub File Size: 1.18 Mb
ISBN: 253-1-84562-628-1
Downloads: 32371
Price: Free* [*Free Regsitration Required]
Uploader: Shakami

Messages are assigned a severity code and include a message mnemonic, which identifies the source application generating the message.

Configuring the PowerConnect 3324/3348 Switch

When creating a user name, the default priority is “1”, which allows access but not configuration rights. Lucia General Support St.

Console logs are enabled by default and cannot be disabled. There are other special functions which can be performed, but this suspends the installation process and results in a system reboot.

When the community names are changed, access rights are also changed. Enables or disables dynamic VLAN creation. Currently the manuals are carefully prearranged and translated, so they could be fully understood by its users.

In the configuration mode, type the SNMP configuration command with the parameters including community name privatecommunity access right read and write and IP address, as shown in the example below: Open the Authentication Profiles page. Defining Access Profiles The Access Profiles page allows network managers to define profiles and rules for accessing the device. Device Setup Requirements The system provides 6 permanent LAGs. What should a perfect user manual contain? The manuals will serve as an informational aid.


To continue using , please upgrade your browser.

The Multicast Support page opens. The time out periods can be reset using the CLI. Messages are filtered based on their urgency or relevancy. Set the new gateway as active by checking the check box.

Devices supporting SNMP run local software agent. Page Aging time is sec vlan mac address port type Configures the maximum broadcast rate.

Configuring Network Security Multicast Support. Page A u t h e n t i c a t i o n P r o f i l e s P a g e The Authentication Profiles page contains the following options lists: The configuration is erased and the switch config reboots. The Port Security Table page opens. Auto-Negotiation Auto-negotiation allows a device to advertise modes of operation and share information with another device that shares a point-to-point link segment.

This section contains instructions for individually downloading device software to each stacking member:. To open the Line Passwords page: Autotech Service See the contact information for your region. To use the configure context, users must be assigned a privilege level of At this point, a user input can be entered to get the Startup menu if it is necessary to run special procedures that can be invoked from this menu.


Management Access methods can be separately defined for: Adds VLANs to a general port. Page The Access Profiles page contains the following fields: Reactivates an interface that is shutdown due to port security reasons.

By default, this parameter is set to Delk. The serial cable is a female-to-female DB-9 crossover cable. Page Displays the device asset tag.

Configuring Rapid Spanning Tree The Stack Master manuwl stack members must be selected within 15 seconds after booting the device. The default value is 0. Associates a port with a port-channel. Page 91 Indicates that the port is disconnected.


Configuring General Device Tuning Parameters The Port Configuration page opens. The initial configuration describes basic configuration functions with basic security considerations. To connect the device: Queue priorities are defined by the queue length. Viewing counter summary statistics: Security Management And Password Configuration Configuring Rapid Spanning Tree When network topology allows, faster convergence may be possible. This section provides information for defining and configuring Quality of Service QoS parameters.